• 家图标
  • 箭头图标 产品
  • 箭头图标Call-Point 发射机s - UHF (20-86-9000系列)

Call-Point 发射机s - UHF

20-86-9000系列

Ideally suited to a variety of Reception area, retail assistance and control applications, 20-86-9000  is a small, high specification, POCSAG Call-Point paging transmitter utilising the 20-86-5000 paging transmitter printed circuit board. 消息s can be sent directly to pocket pagers, audible or visual alarms or to LCD screens.

The 20-86 range of products can send text messages directly to paging receivers, 提供简单的, lower cost systems since intermediate receivers and transmitters are not required for short range applications.

Using an appropriate receiver, 20-86-9000, can also be used for a general remote control applications such as turning on lights, disabling alarms etc.

Powered by a standard CR2032 coin cell, the transmitter will operate for more than one thousand transmissions under normal conditions before the battery needs to be replaced.

20-86 transmitters support up to five inputs, each of which can be programmed with up to a thirty five character message. The units can be programmed with a serial programming cable (purchased separately) or they can be supplied pre-programmed.

Although the 20-86 is a low power transmitter, when used as a call-point paging transmitter a direct line of sight range of up to eight hundred metres can be expected. When used within buildings the range will be reduced depending upon the building, but it will still be significant.

The 20-86-9000 fits the form factor of many standard electrical face plates so that it can remain in keeping with the surrounding switch gear in cosmetically sensitive areas.

By default 20-86-9000 is supplied with a mounting block, but it can be flush mounted in the same manner as most electrical switch plates if required. 

For configuration software please see the downloads tab.

  • 超高频操作
  • 体积小、重量轻 & 离散
  • Internal cell battery
  • 具有成本效益的
  • Ideal for near distance paging, assistance, duress or operation of lights or doors etc.
  • Capable of operating on existing in-house paging systems
  • 1 or 2 button variants available, each button individually configurable with its own 35-character message
  • Simple 遥测 solution or for use with pocket pagers
  • Commercial paging solution
规范
频率范围 440-470MHz - UHF
Frequency Selection 通过软件
电力供应 3V CR2032 button cell
电池寿命 Approx 5000 transmissions
Approx 5 years standby
电力消耗 Standby: <0.5µA
传输:31日马
传输能量 10mW
信道间隔 25 khz, 12.5kHz,或者6.25千赫
调制 FSK与NRZ数据
偏差 ±4.5 khz,±2.3kHz,或±1.0赫兹
Transmit Duty Cycle Up to 20%; Maximum 30 seconds on time
波特率 512, 1200 and 2400
消息格式 POCSAG; Alphanumeric or Numeric
Configuration Application Sacoto (Salcom Configuration Tool software)
编程电缆 20-51-0001 (USB)
串行端口 9600, N, 8, 1; 3V TTL
天线 内置天线
指标 Red LED (centre): Solid = Transmitting
Rapid flashing = Low battery
Environmental Protection Must be located to be protected from water
Operating Temperature -10ºC to +55ºC (+14ºF to +131ºF)
重量 88克含电池
情况下尺寸 Enclosure: 103mm x 51mm x 43mm (L x W x H)
“Worktop” footprint
Switch height: 4mm
Enclosure Material Polycarbonate (PC)
颜色 白色
类型的审批 (20-86-9001)
En 301 489-2 v2.1.1 (2019-4)
En 300 224 v2.1.1, 2017-06
20-86-9000 Brochure
20-86-9000 Configuration Tool
  • 信息

    The 20-86 range of products can send text messages directly to paging receivers, 提供简单的, lower cost systems since intermediate receivers and transmitters are not required for short range applications.

    Using an appropriate receiver, 20-86-9000, can also be used for a general remote control applications such as turning on lights, disabling alarms etc.

    Powered by a standard CR2032 coin cell, the transmitter will operate for more than one thousand transmissions under normal conditions before the battery needs to be replaced.

    20-86 transmitters support up to five inputs, each of which can be programmed with up to a thirty five character message. The units can be programmed with a serial programming cable (purchased separately) or they can be supplied pre-programmed.

    Although the 20-86 is a low power transmitter, when used as a call-point paging transmitter a direct line of sight range of up to eight hundred metres can be expected. When used within buildings the range will be reduced depending upon the building, but it will still be significant.

    The 20-86-9000 fits the form factor of many standard electrical face plates so that it can remain in keeping with the surrounding switch gear in cosmetically sensitive areas.

    By default 20-86-9000 is supplied with a mounting block, but it can be flush mounted in the same manner as most electrical switch plates if required. 

    For configuration software please see the downloads tab.

  • Details
    • 超高频操作
    • 体积小、重量轻 & 离散
    • Internal cell battery
    • 具有成本效益的
    • Ideal for near distance paging, assistance, duress or operation of lights or doors etc.
    • Capable of operating on existing in-house paging systems
    • 1 or 2 button variants available, each button individually configurable with its own 35-character message
    • Simple 遥测 solution or for use with pocket pagers
    • Commercial paging solution
  • 规范
    规范
    频率范围 440-470MHz - UHF
    Frequency Selection 通过软件
    电力供应 3V CR2032 button cell
    电池寿命 Approx 5000 transmissions
    Approx 5 years standby
    电力消耗 Standby: <0.5µA
    传输:31日马
    传输能量 10mW
    信道间隔 25 khz, 12.5kHz,或者6.25千赫
    调制 FSK与NRZ数据
    偏差 ±4.5 khz,±2.3kHz,或±1.0赫兹
    Transmit Duty Cycle Up to 20%; Maximum 30 seconds on time
    波特率 512, 1200 and 2400
    消息格式 POCSAG; Alphanumeric or Numeric
    Configuration Application Sacoto (Salcom Configuration Tool software)
    编程电缆 20-51-0001 (USB)
    串行端口 9600, N, 8, 1; 3V TTL
    天线 内置天线
    指标 Red LED (centre): Solid = Transmitting
    Rapid flashing = Low battery
    Environmental Protection Must be located to be protected from water
    Operating Temperature -10ºC to +55ºC (+14ºF to +131ºF)
    重量 88克含电池
    情况下尺寸 Enclosure: 103mm x 51mm x 43mm (L x W x H)
    “Worktop” footprint
    Switch height: 4mm
    Enclosure Material Polycarbonate (PC)
    颜色 白色
    类型的审批 (20-86-9001)
    En 301 489-2 v2.1.1 (2019-4)
    En 300 224 v2.1.1, 2017-06
  • 手册 & 下载
    20-86-9000 Brochure
    20-86-9000 Configuration Tool

Does your project needs a reliable wireless component?

Not sure how your project can benefit from our systems? 与…取得联系
discuss your requirements with our wireless engineers.